





Raising a numbers to the power which is a positive whole numberThe concept of logarithms arose from that of powers of numbers. If the properties of powers are familiar to you, you may quickly skim through the material below. If notwell, here are the details. Powers of a number are obtained by multiplying it by itself. For instance
The number in the subscript is known as an "exponent." The special names for "squared" and "cubed" come because a square of side 2 has area 2^{2} and a cube of side 2 has volume 2^{3}. Similarly, a square of side 16.3 has area (16.3)^{2} and a cube of side 9.25 has volume (9.25)^{3}. Note the use of parenthesesthey are not absolutely needed, but they help make clear what is raised to the second of 3rd power. Quick Quiz:
Multiplying powersNote thatsince the first term contributes three factors of 2 and the second term contributes twotogether, 5 multiplications by 2. The same will hold is "2" is replaced by any number. So, if that number is represented by "x" we get and in general (since there is nothing special about 2 and 3 which will not hold for other whole numbers) The most widely used powers by whole numbers, for users of the decimal system, are of course those of 10 10^{1} = 10 ("ten") 10^{2} = 100 ("hundred") 10^{3} = 1000 ("thousand") 10^{4} = 10,000 ("ten thousand") 10^{5} = 100,000 ("a hundred thousand") 10^{6} = 1,000,000 ("a million") Note that here the "power index" also gives the number of zeros. For larger numbers, it used to be that in the US 10^{9} = 1,000,000,000 was called "a billion" while in Europe it was called a "milliard" and one had to advance to 10^{12} to reach a "billion." These days the US convention is gaining ground, but the world remains divided between nations where the comma denotes what we call "the decimal point", while the point divides large numbers, e.g. 10^{9} = 1.000.000.000 (in the US commas would be used). It also should be noted that some cultures have assigned names to some other powers of 10e.g. the Greeks used "myriad" for 10,000 while the Hebrew Bible named it "r'vavah," and in India "Lakh" still means 100,000. A 9year old in 1920 coined the name "Googol" for 10^{100}, but the word found little use beyond inspiring the name of a search engine on the worldwide web. Dividing one power by anotherIn a manner very similar to the above, we can writeHere too the number raised to higher power need not be 2again, denote it by xand the powers need not be 5 and 2, but can be any two whole numbers, say a and b: Here however a new twist is added, because subtraction can also yield zero, or even negative numbers. Before exploring that direction, it helps outline a general course to follow. Expanding the meaning of "Number"Back at the dim beginnings of humanity, "numbers" simply meant positive whole numbers ("integers"): one apple, two apples, three apples...Simple fractions were also found useful1/2, 1/3 and so on. Then zero was added, originally from India. Then negative numbers were given full statusrather than view subtraction as a separate operation, it was reinterpreted as addition of a negative number. Similarly, to every integer x there corresponded an "inverse" number (1/x) (many calculators have a 1/x button too). In ancient Egypt, 5000 years ago, these were the only fractions recognized, and they are therefore still sometimes called "Egyptian fractions." When an Egyptian of that time wanted to express 3/4, it was presented as (1/2 + 1/4). Sometimes long expressions were needed, e.g The ancient Greeks went further and defined as "rational number" (or "logical" numbers"rational" comes from Latin) any multiple of such an inverse, for instance 4/13, 22/7 or 355/113. Rational numbers are dense: no matter how close two of them are to each other, one could always place another rational number between themfor instance, half their sum is one choice among many. Decimal fractions which stop at some length are rational numbers too, though decimal fractions having infinite length but with a repeating pattern (0.33333..., 0.575757... etc.) can always be expressed as rational fractions. Greek philosophers in the early days of mathematics were therefore surprised to find that in spite of that density, some extra numbers could still "hide" between rational ones, and could not be represented by any rational number. For instance, √2 is of this class, the number whose square equals 2. Most square roots and solutions of equations are also of this kind, as is π, the ratio between the circumference of a circle and its diameter (denoted by the Greek letter "pi"). Pi has a fair approximation in 22/7 and a much better one in 355/113, but its exact value can never be represented by any fraction. Mathematicians view all the preceding types of number as a single class of "real numbers". Logarithms of positive numbers are real numbers, too. When one writes (the dots represent an irregular continuation) one views it as 10 raised to a power which is some real number.Earlier, powers were integers, denoting the number of times some number was multiplied by itself. To make the above expression meaningful, it is therefore necessary to generalize the concept of raising a number to some power to where any real number can be the power index. Logarithms of powers of 10These are all whole numbers::
These logarithms also satisfy the rules we found (x^{a}).(x^{b}) = x^{(a+b)} So if x=10 U = (10^{a}) V = (10^{b}) W = (10^{(a+b)}) = U.V then since a = log U b = logV (a+b) = log W we have logV + log U = log (U.V) This relation holds whenever U and V are powers of 10:
As the concept of logarithm is broadened, that property always remains. That is what originally made logarithms useful: converting multiplication into addition. Instead of having to multiply U and V, we only need add their logarithms and then look for the number whose logarithm equals that sum: that will be the product (U.V). Similarly, (x^{a}) / (x^{b}) = x^{(a–b)} so if x=10, U = (10^{a}) V = (10^{b}) W = (10^{(a–b)}) = U/V then in the division we have or "the logarithm of the quotient is the difference between the logarithms of the divided numbers," e.g. 10^{7} / 10^{4} = 10^{3} which agrees with 7 – 4 = 3. Division, though, opens up a new territory: by the same rule, for instance 10^{40} / 10^{43} = 10^{–3} = 0.001 And 10^{4} / 10^{4} = 10^{0} = 1 since a number is being divided by itself must equal 1. Indeed, this is consistent with the rule, the adding or subtracting 1 to the logarithm moves its number one decimal to the right of left. Earlier
and now this can be extended, dividing by 10 at each step
The above demonstrates another property of logarithms: Log (VQ) = Q log V For the special case V = 10, logV = 1 Scientific NotationThe quantities with which scientists work are sometimes very small or very large. It is then convenient (for calculation, and also for applying logarithms) to separate the number into two partsa number from 1 to 10, giving its structure, and a power of 10, giving the magnitude.Electric charge, for instance, is measured in coulombs: about one coulomb flows each second through a 100watt lightbulb. That current is carried by a huge number of tiny negative particles, found in any atom and known as electrons. Each electron carries a charge of If this were to be written as a decimal fraction, the expression would take about half a line, with 18 zeros following the decimal point in front of the significant digitsand a quick look at it would not give much information, one still would have had to count the zeros. The mass of the electron is similarly small Scientific notation simplifies writing such numbers. Yet another example is the speed of light Scientific notation also makes multiplication and division easier and less error prone. One multiplies or divides separately the numerical factors, each between 1 and 10, and usually sees at a glance if the result is of the right range of magnitude. Separately, one adds together all power exponents of multiplied factors, and subtracts those of divided ones, to get the appropriate power of 10 which then appears in scientific notation. Of course, in any calculation, one must use consistent unitsit would not do to mix meters and inches, or pounds and grams (such inconsistent use apparently led to an error which caused a space probe to Mars to miss the planet and get lost). The most common consistent system in physics and technology is the MKS system, measuring distance in meters, mass in kilograms and time in seconds. All other units are determined by the choice of these three standards, and as long as one stays in the MKS system, results conform to units of that system too (e.g. if energy is being calculated, it always comes out in joules). An exampleElectrons of the polar aurora ("northern lights") move at about 1/5 the velocity of light, in a magnetic field B which near the ground is about 5 10^{–5} Tesla (the Tesla is the MKS unit of magnetic field: at the pole of an iron magnet you get about 1 Tesla). The magnetic field causes an electron to spiral around the direction of the magnetic force ("magnetic field line") with a radius ofwhere v is the part of the velocity perpendicular to the direction of B. If vthe component perpendicular to Bis half the total velocity, what is r? We have
v = 2.99791 10^{7} m/sec (= 0.1 c) q = 1.60219 10^{–19} coulomb B = 5 10^{–5} Tesla Collecting all numerical factors, and rounding off to 3 decimals (9.11).(3.00)/[(1.6).(5)] = 3.42 Collecting all exponents (– 29+7) – (–19 – 5) = (– 22) – (– 24) = +2 The radius is therefore 3.42 10^{2} meters or 342 meters. That is the order of the radius of a very thin auroral ray, seen from the ground. Considering that the ground from which aurora is usually viewed is 100 kilometers below the aurora, such a ray must appear as very thin indeed. 
Author and Curator: Dr. David P. Stern
Mail to Dr.Stern: stargaze("at" symbol)phy6.org .
Last updated 9 November 2007